Take Down Limp Slippers
Posted: Tue Jun 27, 2017 7:14 pm
I'm in the process of grafting a set of samick sage limbs onto a nighthawk/lightning riser. The bolt and insert fits fine, but the riser has a pin intended for the nighthawk limbs, so I'm contemplating whether to cut the pin down and install a slipper for alignment, or to drill and insert a sheath for the pin in the limbs.
Slippers seem to be somewhat hard to get hold of, and by the time shipping etc. is added it's hardly worth it. I mocked up a glass one today and think it wouldn't be too hard to make up but just wanted to check if there were any other options out there, or I'm risking a blow up going with glass.
I think I want to stay with the slipper rather than the pin so I don't have to drill the limbs, plus I plan on making some other limbs for the same riser as well, so as long as they fit the slipper I'm good to go.
Any ideas/suggestions?
Steve
Slippers seem to be somewhat hard to get hold of, and by the time shipping etc. is added it's hardly worth it. I mocked up a glass one today and think it wouldn't be too hard to make up but just wanted to check if there were any other options out there, or I'm risking a blow up going with glass.
I think I want to stay with the slipper rather than the pin so I don't have to drill the limbs, plus I plan on making some other limbs for the same riser as well, so as long as they fit the slipper I'm good to go.
Any ideas/suggestions?
Steve