Well I reckon its Cactus
Moderator: Moderators
Well I reckon its Cactus
My great plains hasn't been used much of late as I have another bow I usually reach for first, so I went to let a few arrows go with him today . Its a take down recurve and noticed a dirty great crack on the limb as I was putting the stringer on.
This crack is on both sides of the top limb. On one side in particular it nearly travels the entire length of the working part of the limb.
I got it quite a while ago and it has had a fair run, but it shouldn't have failed like that.
I have always used a stringer on this bow and taken good care not to twist the limbs in any way, but I cant help but feel the type of stringer they supply contributed to its demise.
Firmly believing a tip to tip stringer is far superior to the ones with the tacky rubber thingy on it.
I did have some thoughts of sending it back to the factory, but don't care to run the gauntlet of them finding some technical loop hole to reneg on and then slug me for the replacement limbs on top let alone freight. I would rather give that money to someone locally.
Wasn't all that fussed about chancing getting caned on the "Niagra Falls" by the lower limb and string when and if it chooses to let go if I had it repaired If it was possible of course (which I doubt)
Anyway, I just thought someone out there would feel my pain. The loss of an old friend.
Hazard
This crack is on both sides of the top limb. On one side in particular it nearly travels the entire length of the working part of the limb.
I got it quite a while ago and it has had a fair run, but it shouldn't have failed like that.
I have always used a stringer on this bow and taken good care not to twist the limbs in any way, but I cant help but feel the type of stringer they supply contributed to its demise.
Firmly believing a tip to tip stringer is far superior to the ones with the tacky rubber thingy on it.
I did have some thoughts of sending it back to the factory, but don't care to run the gauntlet of them finding some technical loop hole to reneg on and then slug me for the replacement limbs on top let alone freight. I would rather give that money to someone locally.
Wasn't all that fussed about chancing getting caned on the "Niagra Falls" by the lower limb and string when and if it chooses to let go if I had it repaired If it was possible of course (which I doubt)
Anyway, I just thought someone out there would feel my pain. The loss of an old friend.
Hazard
Politics is a game played by dishonest people to gain an unfair advantage!
Never under estimate the strength of a cornered coward.
Everyone is entitled to be stupid, but some abuse the privilege.
http://www.bowmanstaxidermy.com.au
Never under estimate the strength of a cornered coward.
Everyone is entitled to be stupid, but some abuse the privilege.
http://www.bowmanstaxidermy.com.au
Re: Well I reckon its Cactus
ouch that's too bad hazard.
I lost one last week, but that's really disappointing to lose a Great Plains that is an expensive well regarded bow.
I lost one last week, but that's really disappointing to lose a Great Plains that is an expensive well regarded bow.
"So long as the new moon returns in heaven a bent, beautiful bow, so long will the fascination of archery keep hold in the hearts of men" The Witchery of Archery, Maurice Thompson
Re: Well I reckon its Cactus
Morning Graydon
that is not good news and Great Plains are not that common in Aus.
Perhaps what you need to do is make a new limb/set of limbs or have you considered modifying a a new set of limbs to suit the 'Great Plains'?
that is not good news and Great Plains are not that common in Aus.
I agree. Whilst I own a few of those types of "stringers" I prefer not to use them and would not advocate their use.hazard wrote:I have always used a stringer on this bow and taken good care not to twist the limbs in any way, but I cant help but feel the type of stringer they supply contributed to its demise.
Firmly believing a tip to tip stringer is far superior to the ones with the tacky rubber thingy on it.
Perhaps what you need to do is make a new limb/set of limbs or have you considered modifying a a new set of limbs to suit the 'Great Plains'?
Grahame.
Shoot a Selfbow, embrace Wood Arrows, discover Vintage, be a Trendsetter.
"Unfortunately, the equating of simplicity with truth doesn't often work in real life. It doesn't often work in science, either." Dr Len Fisher.
Shoot a Selfbow, embrace Wood Arrows, discover Vintage, be a Trendsetter.
"Unfortunately, the equating of simplicity with truth doesn't often work in real life. It doesn't often work in science, either." Dr Len Fisher.
- Stickbow Hunter
- Supporter
- Posts: 11637
- Joined: Sat Jul 26, 2003 8:33 pm
- Location: Maryborough Queensland
Re: Well I reckon its Cactus
Well I reckon you're right.hazard wrote:Well I reckon its Cactus
Seriously mate sorry to see. It is never good when a bow breaks however as long as bows are made their will be bows breaking. I don't know of any bow maker who as been making bows for any length of time that hasn't had their failures.
It's not good when it happens to you but sadly it does. Often you will not have done anything wrong at all as there would have been an unknown fault or weakness in a lamination or such and over time it has stressed and finally failed. Let's hope that is your last bow to break.
Jeff
Re: Well I reckon its Cactus
I must have misunderstood when we spoke on the phone the other day, I had the impression the crack was through the limb the other way, IE; perpendicular to the flat face of the limb. It appears to me the timber lamination it self has failed, not the glue, and failed over the end of the wedge which is a very highly stressed area in most bows. (The main reason I use such a long, finely tapered wedge in my bows).
Because it's the timber that has let go and not the glue, there is the slim possibility that with the right glue, a syringe and a little care it could be brought back to a tenuous life.
Failing that, my condolences mate.
Cheers, Rob.
Because it's the timber that has let go and not the glue, there is the slim possibility that with the right glue, a syringe and a little care it could be brought back to a tenuous life.
Failing that, my condolences mate.
Cheers, Rob.
The shortest distance between two points is a FLATLINE
Email; robnicoll(at)bigpond(dot)com
www.flatlinebows.com.au
Email; robnicoll(at)bigpond(dot)com
www.flatlinebows.com.au
-
- Posts: 550
- Joined: Sun Jan 07, 2007 9:43 am
- Location: Melbourne Australia
Re: Well I reckon its Cactus
Hi Hazard...I have had a bit to do with Bill and Linda Foreman's bows over the years and always found them straight up operators real proud of their product. If you feel all is not well worth running past them to see if they will assist.
Re: Well I reckon its Cactus
Mate i had a great plains bow and it was fantastic, i would send them an email and see if they will come to the party as it would be sad to see it go.
Dan
Dan
Re: Well I reckon its Cactus
Mate I agree, I really enjoyed this bow and I really cant fault its performance.Fanto wrote:Great Plains that is an expensive well regarded bow.
Yes thats already being formulated from another direction.GrahameA wrote:Perhaps what you need to do is make a new limb/set of limbs or have you considered modifying a a new set of limbs to suit the 'Great Plains'?
To be honest yes, and I cant fault Great Plains on that as it could happen to any bow any time. But these days I am just lucky like thatStickbow Hunter wrote:Often you will not have done anything wrong at all as there would have been an unknown fault or weakness in a lamination or such and over time it has stressed and finally failed.
I value my manhood too much to risk going down this path. But not to worry I can feel a Great Flatline coming onFlatliner wrote:there is the slim possibility that with the right glue, a syringe and a little care it could be brought back to a tenuous life.
Thanks for offering mate, but I am not comfortable asking when the bow is clearly out of the waranted time frame ( i feel like I would be preying on someones good nature) If you know what I mean. The costs at the end of the day will probably come out the same as getting them re-made. Though I could possibly contact them to see what their thoughts are in the matter. I should sleep on it a couple of days and see what presents itselfhardgainer wrote:Hi Hazard...I have had a bit to do with Bill and Linda Foreman's bows over the years and always found them straight up operators real proud of their product. If you feel all is not well worth running past them to see if they will assist.
It won't be gone completely, just re-born in a hybrid But yes it was a very good bow.dan76 wrote:Mate i had a great plains bow and it was fantastic, i would send them an email and see if they will come to the party as it would be sad to see it go.
Dan
Thanks guys
Hazard
Politics is a game played by dishonest people to gain an unfair advantage!
Never under estimate the strength of a cornered coward.
Everyone is entitled to be stupid, but some abuse the privilege.
http://www.bowmanstaxidermy.com.au
Never under estimate the strength of a cornered coward.
Everyone is entitled to be stupid, but some abuse the privilege.
http://www.bowmanstaxidermy.com.au
- looseplucker
- Posts: 1558
- Joined: Tue Jan 02, 2007 10:32 am
- Location: Canberra